Table of Contents Previous Next


6 Upgrading to BART 2.4

Section 6.1 describes the upgrade process from BART 2.0 to 2.4.
Section 6.2 describes the upgrade process from BART older versions (except 2.0) to 2.4.
When using BART 2.4, the BART backup catalog (as specified by the backup_path parameter of the BART configuration file) must not be the same directory that was used by the older BART versions for their backup catalogs. In other words, new full backups and incremental backups taken using BART 2.4 must be stored in a new BART backup catalog.
Note: On any remote host on which incremental backups were restored using the earlier BART version, the same installation process must be performed in a similar manner as on the BART host.

6 Upgrading to BART 2.4

Table of Contents Previous Next