Table of Contents Previous Next


3 JDBC Installation : 3.1 Using an RPM Package to Install the Connector

After downloading the repository configuration file, assume superuser privileges, and use the following command to create the repository configuration file:
rpm –Uvh edb-repo-x.x-x.noarch.rpm
The installer creates a repository configuration file named edb.repo; the file resides in /etc/yum.repos.d. The file contains entries for each of the EnterpriseDB repositories; to install the connector, you must enable the entry for the enterprisedb-tools repository:
[enterprisedb-tools]
name=EnterpriseDB Tools $releasever - $basearch
baseurl=http://<
user_name>:<password>@yum.enterprisedb.com/tools/redhat/rhel-$releasever-$basearch
enabled=1
gpgcheck=1
gpgkey=file:///etc/pki/rpm-gpg/ENTERPRISEDB-GPG-KEY
1.
Replace the user_name and password placeholders in the baseurl specification with your user name and the repository password.
2.
Replace the 0 next to enabled with a 1.
After modifying the content of the repository configuration file, you can use the yum install command to install the connector; use the command:

3 JDBC Installation : 3.1 Using an RPM Package to Install the Connector

Table of Contents Previous Next