Table of Contents Previous Next


5 Upgrading a Graphical Installation with an RPM Package on a Linux Host : 5.2 Upgrading a PEM agent Installed with a Graphical Installer

The default installation location for the PEM server when installed by the graphical installer is /opt/edb/pem. In the example that follows, substitute your server installation location for PEM_installation_path.
5.
When the repository configuration file installation completes, use your choice of editor to modify the dependencies and tools repository definitions, ensuring that the repository definitions are enabled and providing the correct repository credentials:
6.
The yum makecache command downloads the metadata for the currently enabled repositories; when the command completes, check the available packages to confirm that the list includes the latest PEM agent:
Then, set the value of the ca_file parameter:
Then, copy the agent certificates; in the following commands, agent_id should specify the agent identifier (for example, agent2 or agent3):
mv /root/.pem/agent_id.key /root/.pem/agent_id.key.bkp
mv /root/.pem/agent_id.crt /root/.pem/agent_id.crt.bkp
mv /root/.pem/agent_id.key.bkp /root/.pem/agent_id.key
mv /root/.pem/agent_id.crt .bkp /root/.pem/agent_id.crt
13.
Enable the pemagent service, and start pemagent and httpd. On a RHEL or CentOS 7.x host, use the commands:

5 Upgrading a Graphical Installation with an RPM Package on a Linux Host : 5.2 Upgrading a PEM agent Installed with a Graphical Installer

Table of Contents Previous Next