20.7. SSPI Authentication
SSPI is a Windows
technology for secure authentication with single sign-on.
PostgreSQL will use SSPI in
negotiate mode, which will use
Kerberos when possible and automatically
fall back to NTLM in other cases.
SSPI authentication only works when both
server and client are running Windows,
or, on non-Windows platforms, when GSSAPI
When using Kerberos authentication, SSPI works the same way GSSAPI does; see Section 20.6 for details.
The following configuration options are supported for SSPI:
If set to 0, the realm name from the authenticated user principal is stripped off before being passed through the user name mapping (Section 20.2). This is discouraged and is primarily available for backwards compatibility, as it is not secure in multi-realm environments unless
krb_realmis also used. It is recommended to leave
include_realmset to the default (1) and to provide an explicit mapping in
pg_ident.confto convert principal names to PostgreSQL user names.
If set to 1, the domain's SAM-compatible name (also known as the NetBIOS name) is used for the
include_realmoption. This is the default. If set to 0, the true realm name from the Kerberos user principal name is used.
Do not disable this option unless your server runs under a domain account (this includes virtual service accounts on a domain member system) and all clients authenticating through SSPI are also using domain accounts, or authentication will fail.
If this option is enabled along with
compat_realm, the user name from the Kerberos UPN is used for authentication. If it is disabled (the default), the SAM-compatible user name is used. By default, these two names are identical for new user accounts.
Note that libpq uses the SAM-compatible name if no explicit user name is specified. If you use libpq or a driver based on it, you should leave this option disabled or explicitly specify user name in the connection string.
Allows for mapping between system and database user names. See Section 20.2 for details. For a SSPI/Kerberos principal, such as
username@EXAMPLE.COM(or, less commonly,
username/hostbased@EXAMPLE.COM), the user name used for mapping is
username/hostbased@EXAMPLE.COM, respectively), unless
include_realmhas been set to 0, in which case
username/hostbased) is what is seen as the system user name when mapping.
Sets the realm to match user principal names against. If this parameter is set, only users of that realm will be accepted. If it is not set, users of any realm can connect, subject to whatever user name mapping is done.