Table of Contents Previous Next


2 Upgrading a PEM Installation : 2.2 Upgrading the PEM Server

./pem_server-x.x.x-linux.run
Where x.x.x specifies the version information for the installer.
C:\Users\susan\AppData\Local\Temp\vmware-susan\VMwareDnD\05175ec4\one.png
The PEM Server Setup Wizard welcomes you, as shown in Figure 2.7. Click Next to continue to the License Agreement.
C:\Users\susan\AppData\Local\Temp\vmware-susan\VMwareDnD\8a3f83f5\pstwo.png
The PEM server setup wizard will prompt you to accept the License Agreement (shown in Figure 2.8). After reviewing the license agreement, check the radio button next to I accept the agreement, and click Next to continue to the Existing installation dialog.

C:\Users\susan\AppData\Local\Temp\vmware-susan\VMwareDnD\d5412951\psthree.png

C:\Users\susan\AppData\Local\Temp\vmware-susan\VMwareDnD\d7cb600a\one.png

C:\Users\susan\AppData\Local\Temp\vmware-susan\VMwareDnD\8a3e8356\psfive.png
The wizard then opens the Database Server Installation Details dialog, prompting you for connection credentials for database superuser of the PEM backing database (see Figure 2.11). Provide:
Click Next to continue.
C:\Users\susan\AppData\Local\Temp\vmware-susan\VMwareDnD\883e85ff\pssix.png
The Ready to Install dialog will inform you that the setup wizard is ready to perform the installation. Click Next to start the installation (see Figure 2.12).

C:\Users\susan\AppData\Local\Temp\vmware-susan\VMwareDnD\883c85d9\psseven.png
C:\Users\susan\AppData\Local\Temp\vmware-susan\VMwareDnD\c548198b\pseight.png
Click OK to close the Info popup. The PEM server setup wizard informs you that the installation is complete (see Figure 2.15).
C:\Users\susan\AppData\Local\Temp\vmware-susan\VMwareDnD\48ebcbaf\three.png
If you have installed the PEM backend database server and PEM-HTTPD on different hosts, then you must run the PEM server installer twice – once on each host. Extract the language pack installer, and install it on the host of PEM-HTTPD before invoking the PEM installer. Include the following keywords when invoking the installer to extract the language pack:
The data directory path for the PEM backing database.
The directory for the database server installation. For example, /usr/edb/as10 for Advanced Server or /usr/pgsql-10 for PostgreSQL.
The installation type: Specify 1 if the configuration is for web services and backing database, 2 if you are configuring web services, or 3 if you are configuring the backing database. If you specify 3, please note that the database must reside on the local host.
For detailed information about using an RPM package to install or configure the PEM server, please see the PEM Installation Guide or the Advanced Server Installation Guide, available at:

2 Upgrading a PEM Installation : 2.2 Upgrading the PEM Server

Table of Contents Previous Next